Installation guide

A small upgrade. A simple setup.

01 / Power it

Insert three AAA batteries, matching the polarity marks. Switch on and test the projector before mounting.

02 / Find the fit

Hold the light against a flat area low on the inside door panel with the lens pointing down. Check the projection and make sure the door closes freely.

03 / Clean & mount

Clean and dry the mounting surface using a method safe for your trim. Apply the mounting adhesive and press firmly. Follow the adhesive instructions before use.

04 / Align & test

Position the door magnet opposite the sensor as directed by the included guide. Open and close the door to confirm the light switches on and off.

Follow the guide supplied with your unit. Keep the light clear of door seals, drains and safety equipment. Do not force the door shut. Best viewed at night; visibility varies with the surface and lighting.